It happens sometimes that a heated object does not have a brick chimney or benefit from it is impossible, so it is necessary to other universal solution to the combustion of the heating device. As usual, the need arises solution, and this is the case acid-resistant outer double wall insulated chimney.

ELEMENTS OF CHIMNEY acid-resistant

Technical Overview
The various components of the chimney are made of acid-resistant chimney, with the difference that the additional thermal insulation has a thickness of 40 or 50 mm and outer sheath made of stainless steel 1.4301 and a symbol of the thickness of 0.5 mm. The specific construction and clamp connectors ensure the tightness of the system. Offered by our company stacks are available in diameters (ext / cry): 130/210 mm 150/250 mm 180/260 mm 200/300 mm 250/350 mm 300/400 mm 350/450 mm.

Destiny
The proposed chimneys are designed to exhaust gas-fired boiler or heating oil. Can be mounted both inside and outside the building.

Installation Instructions
Installation of insulated chimney should begin to clarify the location of tee, as straight as possible so that you can build a flue. Then assemble the tee, and odskraplacz cleaning hole, in order to determine where the base foundation assembly. Next, assemble the pipe from the tees. All combine to secure the bandage. Mounting successive sections of pipe to keep in mind the need for mounting brackets and clamps at intervals of about 2.5 m. If the wall, which is mounted a stack is too low, you can release up to 1.5 m stack (the value depends on the diameter of the chimney) over the last bracket , or up to 3 meters using a clamp at the exhaust.

Cleaning hole shall be so installed that was provided to its permanent, unrestricted, access.

Condensate to be discharged into the condensate neutralizer, air-tight container or directly into the sewage system (if it would allow law).

In accordance with applicable laws, any contribution of chimney stack and is subject to the accepted kominiarskiemu.