So, how is the dynamic development of heating technology, yes, behind it follows the development of the art tower. The aim of producers of heating devices is the maximum energy saving and environmental protection, more complete combustion process by a factor, lower power devices, and reduce exhaust gas temperature. Consequence of such conduct reflects upon the nature of gases, and thus, in the chimney. The exhaust gases are getting cooler, more and more aggressive dropping of condensates, which may lead to unsafe chimney damage, respectively.

Contribution stainless ELEMENTS

Technical Overview
One way to secure the chimney, probably the safest, is to install the steel chimney. Contributions chimney is made of stainless steel. The offer is as smooth, with diameters ranging from 80 mm to 450 mm. Stainless steel chimney contribution is made of steel with a thickness of 0.5 ÷ 0.8 mm, depending on diameter. All parts of the tube are linearly combined plasma arc welding technology. The various components are assembled together Socket.

Application
Stainless steel chimney liners are designed to exhaust gas-fired boiler or heating oil. The specific purpose - to old, even the curves of chimneys, can have a flexible tube version with stainless steel, made of strips with a thickness of 0.12 mm, which guarantees the integrity of a performance. To connect the flexible pipe used kształtkami hose.

Installation Instructions
Before installing the chimney should be thoroughly cleaned glass ceramic chimney. Then, in the boiler room, you should carve a hole that allows mounting tee, and the washout hole in the glass chimney odskraplacza. The rest is mounted chimney from the top, ie from the exit of the chimney. Fix the rope to the pipe with a length of 1 m, it recessed into the shaft until only a cup of originality, we assume another tube, noting the total sliding one tube in the cup, and again leave the other until the projection in the cup. These steps repeat until the hole will be cut into the tip of the first pipe. Install the tee, and odskraplacz cleaning hole, and then combine them with pipes. The last pipe protruding from a stack cut to length such that they can be mounted in the cup final tube roof plate and fasten it to the crown of the chimney. The roof panel mount wywiewkę or deflector. Location of the tee is dependent on how to lead from the boiler flue. Closure of the washout hole should be set so as to be able to freely access the washout hole. Condensate to be discharged into the condensate neutralizer, air-tight container or directly into the sewage system (if it would allow law).

Additional isolation, partial or the entire length of chimney, substantially improve the working conditions chimney, as well as its lifetime.

In accordance with applicable laws, any contribution of chimney stack and is subject to the accepted kominiarskiemu